Název:	Effect of scanning speed when measuring surface roughness
Autoři:	Kubátová, Dana Melichar, Martin
Citace zdrojového dokumentu:	KUBÁTOVÁ, D., MELICHAR, M. Effect of scanning speed when measuring surface roughness. In: Annals of DAAAM and Proceedings of the International DAAAM Symposium. Vídeň, Rakousko: DAAAM International Vienna, 2018. s. 1249-1255. ISBN 978-3-902734-20-4 , ISSN 1726-9679.
Datum vydání:	2018
Nakladatel:	DAAAM International Vienna
Typ dokumentu:	konferenční příspěvek conferenceObject
URI:	2-s2.0-85060085857 http://hdl.handle.net/11025/31139
ISBN:	978-3-902734-20-4
ISSN:	1726-9679
Klíčová slova v dalším jazyce:	feed rate;D-optimal design;software filter;surface roughness
Abstrakt v dalším jazyce:	In the field of practical metrology it is extremely important not only accuracy but also the measurement of measuring productivity activities which entail considerable costs. Within this article, was tested the influence of the velocity for measuring of roughness. Test was made in in controlled laboratory conditions on the quality and accuracy of the measurements In this paper experiment described test that was performed on standard pieces with defined Ra and Rz values. The test was performed on the principle of repeated measurement at different speeds. The speed was 0.1-3 mm / s, which is the range of Hommel Etami T 8000. This machine is currently used for calibration at the Czech Metrology Institute and is one of the leading machines for measuring roughness in technical practice. The results obtained clearly declare the effect on the results of the measured values. All measured data underwent statistical processing and subsequently verification of its accuracy.
Práva:	Plný text je přístupný v rámci univerzity přihlášeným uživatelům. © DAAAM International Vienna
Vyskytuje se v kolekcích:	Konferenční příspěvky / Conference Papers (RTI) OBD

Všechny záznamy v DSpace jsou chráněny autorskými právy, všechna práva vyhrazena.